Dabop
Master Poster
I find that hard to believe. It is powered by a 427 aluminum FE engine that made 538 BHP on the dyno, with over 500 ft lbs of torque from 2,000 to red line. After the dyno pull we replaced the dual quads with fuel injectors so it should be making a little more horsepower, but may have lost some torque below 3,000 rpms.
Due in part to the aluminum block, the car weighs just over 2,400 lbs with gas in the tank.
From a dead start, all we would learn is that I have to find a new Jaguar rear axle to replace the remaining pieces. However, numerous Cobras set up for drag racing, with similar engines, are running in the 9's.
From a rolling start, I suspect the Model S Plaid would be in for a fight. And, on a road, course, it would be no competition.
I can't resist, here is the FE with EFI:
View attachment 67462
Tesla Model S Plaid achieves new record 8.56-sec quarter mile
A Tesla Model S Plaid has achieved a new record quarter-mile run in a remarkable 8.56 seconds – though it...
electrek.co

Tesla Model S Plaid sets stunning new quarter-mile and 0-60 mph records - Tesla Oracle
Tesla Model S Plaid sets a new record in a quarter-mile drag racing attempt which puts it among the list of top world records. The Tesla Model S Plaid luxury electric sedan completed the 1/4-mile run in just 8.59 seconds at a speed of 162.33 mph (261 km/h). The vehicle did not just make a […]
www.teslaoracle.com
Tesla Model S Plaid sets a new record in a quarter-mile drag racing attempt which puts it among the list of top world records.
The Tesla Model S Plaid luxury electric sedan completed the 1/4-mile run in just 8.59 seconds at a speed of 162.33 mph (261 km/h).
The vehicle did not just make a new quarter-mile record, it also accelerated from 0-60 seconds in just 1.88 seconds. This is 0.11 seconds faster than the best 0-60 mph record of 1.99 seconds by a Model S Plaid.














